In this example, select the Preshared Secret option.
Click Next to configure the Local Endpoint Settings.
Local endpoint settings
Leave the Initiate Tunnel Negotiation checkbox checked.
Note
This option is not available when the SnapGear unit has a static IP address and the
remote party has a dynamic IP address.
Enter the Optional Endpoint ID of the SnapGear unit. This ID is used to authenticate
the SnapGear unit to the remote party. IIt is optional if the tunnel has a static local IP
address and uses Preshared Secrets for authentication. If it is optional and the field is left
blank, the Endpoint ID defaults to the static IP address. The Endpoint ID becomes
required if the tunnel has a dynamic or DNS IP address or if RSA Digital Signatures are
used for authentication.
219
Virtual Private Networking
To Next Page
Loading...
