Command (m for help): p
Disk /dev/sda: 5 heads, 50 sectors, 1024 cylinders
Units = cylinders of 250 * 512 bytes
Device Boot Start End Blocks Id System
/dev/sda1 1 1024 127975 b Win95 FAT32
Delete any existing partitions by typing d the entering the partition number, e.g. enter 1 to
delete /dev/sda1.
Create a new partition by typing n then p for primary, then the partition number.
Note
The SnapGear unit support primary partitions only, so you are limited to four partitions.
Enter the cylinder for the partition to start on, generally the default is fine. Enter the
cylinder for the partition to end on, or a size for the partition with +(size in mb)M.
Command (m for help): n
Command action
e extended
p primary partition (1-4)
p
Partition number (1-4): 1
First cylinder (1-1024, default 1):
Using default value 1
Last cylinder or +size or +sizeM or +sizeK (1-1024, default
1024): +64M
259
USB
To Next Page
Loading...
