BGX701-294-R03, PTD user manual
This option enables you to attach a wired
device with a zone in the heating system.
The wired device is added to
the system
4.1 Advance settings
To access the options grouped under this menu, you require the User or Owner PIN. By
default, the PIN is set to 1854. Details are available in the full user guide.
4.2 Installer settings
Most users will not need to use these settings. This section is mostly useful for local
authorities or those involved in managing housing associations. To access the options
grouped under this menu, you require the Installer PIN. Once received, you can change it
according to your preference, using the Change PIN option. If you lose your PIN, contact
the support team at support@securemeters.com
4.3 System modes
Your PTD has three heating modes: Home, Away and Summer
This is the default mode in which the PTD
follows the heating, hot water and timer
schedules applied by the user. In this
mode, the temperature set point and
boost settings can be changed locally on
the PTD as well as through the mobile
app.
Press the Home-Away button
to toggle between the two
modes.
You can change the default
Away temperature in the PTD,
by clicking Settings.
In the mobile app, tap the
settings icon on the
top right to view this option.
The system will maintain a fixed pre-set
temperature. Heating, timer and hot water
(including boost) schedules will not work
in Away mode, until it is cancelled.
Switch to this mode if you wish to restrict
heating control in all defined zones to
frost protection mode. In this mode, all
heating and timer schedules will stop
however, hot water will continue to work
(including boost functionality). You cannot
change heating and timer settings on the
PTD or mobile app but hot water and
Refer section
Applying the summer mode to
set the device in Summer
mode. The default
temperature is set at 5 degree
Celsius but this can be
changed from the Settings
To Next Page
Loading...
Need help?
General
