First register address – high byte
16-bit register address, register address map
is described in Table 38
First register address – low byte
Number of registers to read – high byte
Number of registers to read must be between
1 to 255
Number of registers to read – low byte
Table 37: Normal response from genset controller slave for Function 3
As configured in genset controller
Equals to number of registers to be read times
two. 8-bit even number between 2 to 250
First register – high byte
First register – low byte
Last register – high byte
12.4 Register Map
The register map for input registers is as shown in Table 38
Table 38: Register map for input registers
Generator power factor L1
Generator power factor L2
Generator power factor L3
Generator average power factor
To Next Page
Loading...
Need help?
General
