EasyManua.ls Logo

Seeley Breezair EXQ - User Manual

Seeley Breezair EXQ
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
(English)
INSTALLATION MANUAL
EXQ / EZQ / EXS Evaporative Coolers
ILL1672-A
Original English Instructions

Questions and Answers

  • M
    mollyrichardsonAug 2, 2025
    Why is my Seeley Air Conditioner not cooling properly?
    • S
      Sandra SullivanAug 2, 2025
      If your Seeley Air Conditioner isn't cooling adequately, several factors could be at play. The cooler might be too small; consider replacing it with a larger one. The ductwork could be undersized, necessitating a cooling load design to determine the correct unit, ducting, and outlet sizes. Check for clogged or dirty cooling pads and clean or replace them. Ensure the pads aren't dry due to obstructions in the water distribution system or pump issues. Also, verify there are enough air discharge openings and adequate exhaust to prevent high humidity. Finally, on days with excessive ambient humidity, the cooler's performance will be reduced, and shutting off the pump might be the only option.
  • S
    Seth BrownAug 7, 2025
    What to do if the pump runs but there is no water circulation in my Seeley Breezair EXQ Air Conditioner?
    • C
      Carmen DurhamAug 7, 2025
      If your Seeley Air Conditioner pump runs but no water is circulating, it could be due to several reasons. First, check if there is insufficient water in the tank, and adjust the float level accordingly. Next, inspect the water hoses for blockages and clean them out. Also, check the pump strainer for blockages and clean it. Ensure that the water supply pressure is sufficient. Finally, verify that the water solenoid is installed in the correct water flow direction.
  • K
    Kent PerezAug 11, 2025
    How to fix a noisy Seeley Breezair EXQ?
    • D
      daisy53Aug 11, 2025
      If your Seeley Air Conditioner is making excessive noise, it might be due to a fan that is out of balance because of dirt. Clean the fan to resolve this. Alternatively, there could be too much back pressure, requiring a re-evaluation of the design, improvement of the duct layout, or changes to grille sizes.
  • C
    Carrie BellAug 15, 2025
    Why does my Seeley Breezair EXQ Air Conditioner have a continuous overflow of water?
    • B
      billy14Aug 15, 2025
      If you're experiencing a continuous overflow of water in your Seeley Air Conditioner, it could be due to several reasons. The float valve adjustment might not be correct, requiring an adjustment. Heavy pad deposits could also be the cause, so clean or replace the pads. Additionally, a drain valve failure could be the issue, necessitating its replacement. Finally, verify that the water solenoid is installed in the correct water flow direction.
  • J
    James BryantAug 19, 2025
    What causes water to enter the cooler outlet in a Seeley Breezair EXQ?
    • J
      Jessica EdwardsAug 20, 2025
      If water is entering the cooler outlet of your Seeley Air Conditioner, check for loose water hose connections and tighten them. Replace any cracked or broken hoses. Ensure the cover is fitted on the float valve, replacing the float valve if necessary. Verify that the pads are correctly fitted into the pad frames and install the pad frame correctly. Replace incorrect or damaged pads with new Chillcell pads.
  • V
    vangdeborahAug 25, 2025
    What to do if the pump fails to operate in my Seeley Breezair EXQ Air Conditioner?
    • J
      johnsonemilyAug 25, 2025
      If your Seeley Air Conditioner pump fails to operate, it could be due to a tripped circuit breaker. Check the pump for faults and replace it if necessary. Another possible cause is pump motor failure, which would also require replacing the pump.
  • D
    daniel22Aug 28, 2025
    Why does my Seeley Breezair EXQ Air Conditioner have an unpleasant odor?
    • H
      Heather RiceAug 28, 2025
      An unpleasant odour from your Seeley Air Conditioner can stem from several causes. New cooler pads may emit an odour; fill the tank, run the pump briefly to wash the pads, drain, and repeat if needed. The odour will dissipate with operation. The cooler might be near an odour source; remove it or relocate the cooler. Algae in the tank water can cause odours; drain the pan, clean thoroughly, refill, and change pads. If pads remain wet after shutdown, run the fan on 'vent' for 10 minutes to dry them. Heavy pad deposits can also cause odours; clean or replace the pads.

Summary

Comprehensive Safety Guidelines

Employer and Employee Safety Duties

Details occupational health and safety duties for employers and employees during cooler installation.

Installer Risk Assessment Procedures

Essential risk assessment steps for installers and maintenance personnel to identify and mitigate hazards.

Cooler Commissioning Procedures

Diagnostic LED Status Interpretation

Explains how to interpret the status of diagnostic LEDs on the cooler's electronics box for troubleshooting.

Salinity LED Functionality

Describes the salinity LED's role in indicating water salinity levels and control method settings.

Advanced Cooler Commissioning and Testing

MagIQtouch Controller Operation Info

Information on viewing cooler status, fault diagnosis, and operational data via the MagIQtouch controller.

Direct Drive Motor Operational Test

Procedure for testing the cooler's electronically commutated Direct Drive Motor for proper function.

Water Level Setting and Testing

Guide to accessing service menus for setting and verifying the correct water level in the cooler tank.

Water Management and Pad Maintenance

Drain Valve Operational Test

Steps to test the drain valve's functionality using the service screen or manual settings.

Pad Frame Installation Guide

Instructions for correctly refitting the evaporative cooler pad frames after servicing or installation.

Evaporative Pad Frame Placement

Cooler Pump Distribution Test

Procedure to test the pump's performance and ensure even water distribution to all cooling pads.

Cooler Operational Settings Adjustment

Setting Temperature Limits

Configuration of minimum and maximum temperature setpoints for the evaporative cooler.

Water Management Method Selection

Selection of water management strategies, including salinity measurement and timed draining.

Autoclean Schedule Configuration

Setting the interval for automatic cooler tank draining, refilling, and cleaning cycles.

Seeley Breezair EXQ Specifications

General IconGeneral
BrandSeeley
ModelBreezair EXQ
CategoryAir Conditioner
LanguageEnglish

Related product manuals