Malfunction status
Cause
Action
Motor stops, chainsaw
won't start
Chainsaw stuck when
cutting
Battery won't charge
Battery charging
protection(> 45℃)
Charger keeps green
light
lnefficient saw cutting
Chain bar overheating
lnsufficient lubrication
of chain & bar
Add chain & bar oil
Battery charging
protection(> 45℃)
Blunt chain
Loose chain
Incorrectly chain
direction
use a 5/32"(4.0mm) file to
sharpen the chain
Keep the battery in shade
for 30-60 minutes before
usingit again.
Keep the battery in shade
for 30-60 minutes before
usingit again.
Check chain tightness
Check whether the
installation direction of the
chain is consistent with
the instruction
without electricity
Check whether the
battery pack has power
Motor overheat
protection(> 120℃)
Battery overheat
protection(> 70℃)
Keep the battery in shade
for 30-60 minutes before
using it again.
Keep the chainsaw in
shade for3o-60 minutes
before using it again.
Low battery
Add chain & bar oil
Fully charge the battery
before using it
lnsufficient lubrication
of chain & bar
Cutting Skills
Troubleshooting
When the machine is not being used over a longer period of time it is
best to store the battery in charged condition.
The battery is used to ensure that it is recharged at least once every 3
months.
The battery has overheat protection and charging protection, which may
be triggered during frequent use or overuse :
a.The chainsaw will not start when the overheat protection is triggered.
Keep the battery in shade for 30-60 minutes before using it again:
b. When the charging protection is triggered, the battery will not be able
to charge, and the green light will continue to show after the charger is
inserted into the battery. Please keep the battery in shade for 30-60
minutes before charging.
For any problems you cannot solve, please feel free to contact our
after-sales mail support@seesiius.com. We'll be happy to solve your
problem.
ln order to make you have a better use experience, we recommend :
Do not press the chain saw hard in use.
To ensure the best service life of the chain saw, please do not overload
the equipment and do not cut branches with a diameter of more than
90mm(CH600,CH600+); 140mm(CH800,CH810). Otherwise the chain
may become stuck.
Please add chain & bar oil to the chainsaw before each use, and the
optimal frequency for oiling a chainsaw is after every10-15 cuts.
You can choose universal chain & bar oil.
Try to avoid tree branches.
When the device is running, keep your other hand is at least 15cm
away from the cutting area of the blade, and the hand must not be put
into the knife edge.
To protect the battery pack in cold or wet weather, place it under
waterproof clothing.
Be sure to unplug the battery pack after the cutting is completed.
Do not use this equipment on rainy days.
Do not use any solvents such as gasoline, alcohol, ammonia, etc.
Chemicals such as these will damage the synthetic components.
-11-
-12-
To Next Page
Loading...