Seg Melbourne - Instructions for Fixing Stand

Instructions for fixing stand
Instructions for fixing stand
Note: the pictures below are only for reference
5 3
The parts
needed for installing the stand (supplied)
Rear cabinet of TV
Screws(4 x ST4 x 16F)
TV stand
TV board
1. Put the stand on the TV set
2. Screw the stand in the positions with the screws supplied (4 x ST4 x 16F).
Installation
(Put your TV on the table with its rear cabinet facing upwards.)
Rear cabinet of TV
TV stand
TV board
Screws:4xST4X16F
60 cm (23.6”) LED BLU-TV Melbourne