- 4 -
Introduction
This manual describes the information on handling and maintenance of PGIS MIGHT FLY
manufactured by VS Electronic Assembly (Zhuhai) Co. Ltd. (authorized by SEGA SAMMY
GROUP Japan). The machine must not be used for other improper purposes. Any adjustment
procedures and maintenance service must be performed by a qualified engineer or technicians who
are comprehensively understands the machine.
The main power switch of the machine is located at the bottom rear panel.
Turn OFF the main power switch before cleaning, inspection, electrical components
replacement, repair, or other procedures. Failure to comply this warning may cause accident as
a result of electrical shock or malfunction.
Operation on the electrical circuitry of the machine must be always performed by a qualified
and trained technician.
Make sure to avoid moisture and dust entering into the machine when it is open. Moisture and
dust may be the source of electrical shock, mechanical failure and other errors.
The description of this system manual should be correct and true to the best of our knowledge.
Please contact us if there is any chance of defect, flaw, or missing information.
* For the event of water drips into the machine accidentally, please temporarily turn off the
machine. Open the door on ticket dispenser and clean up any water that may drain into this
enclosure.
If the supply cord is damaged, it must be replaced by a special cord or assembly available from
the manufacturer or its service agent.
WARNING
Observe the following safety precautions
when operating this machine.
To Next Page
Loading...
Need help?
General
