Unpacking your Genesis 32X
Use the checklist below to make
sure you have all the components
of your Genesis 32X.
• Genesis 32X Unit
• Connector Cable
• Conversion Cable
• Sega Audio/Video Cable
(mono)
• Spacer for New Genesis
Model
• AC Adaptor
• Electromagnetic Shield Plates
(front and rear)
• Instruction Manual (this
booklet)
• Consumer Reply Card
• Discount Coupons (6 $10
coupons)
Caution
The Spacer for New Genesis
Model is specifically designed for
the new Genesis model. Using the
spacer with other models will
damage your unit.
Connecting the Electromagnetic Shield plates
If you own the original Genesis model or the new Genesis model, you need to connect the supplied electromagnetic
shield plates to both sides of the cartridge slot before inserting the Genesis 32X.
Note: Take care not to injure yourself when handling
the electromagnetic shield plates.
1. Take the longer electromagnetic shield plate (for
the rear) as shown in the diagram.
2. Pass the hooks of the electromagnetic shield
plate through the flap of the cartridge slot.
3. Affix the electromagnetic shield plate to the flap
of the cartridge slot.
4. Follow the same procedure for the shorter
electromagnetic shield plate (for the front).
To Next Page
Loading...
Need help?
General
