Segway Drift W1 User Manual

4 Charging
a. Open the rubber cap
b. Insert the plug into the charge port
Your Segway Drift is fully charged when the
LED on the charger changes from red
(charging) to green (trickle charge). Close
the rubber cap when not charging.
* You can charge both mainframes at the
same time.
There are safety risks when learning to ride the Segway Drift. You must
read this User Manual and follow the New Rider Tutorial by scanning the
QR code on the Welcome Card before your first ride.
Whenever the Segway Drift is powered on, it MUST stay on the ground. To avoid injury do not touch the wheel with any
part of your body.
a
b
Do not connect the charger if the charge port or charge cable is wet.
The battery pack is only to be charged by adults.
5 Before Riding
Always turn off the
Segway Drift before you
lift it off the ground.
Connection Port
Charge Port
Foot Mat
Rubber
Bumper
Wheel
3 Diagram
Power Level Indicator
Power Button
Glow light
Bottom View
Glow light
Handle
Handle
Wheel
● Power ON/OFF:
The Segway Drift must be on the ground when powered on or off. To avoid injury do not touch the wheel with any
part of your body.
Power on: Press the power button, the power level indicator lights will turn on and the Segway Drift will beep twice.
Power off: Press the power button, the power level indicator lights will turn off and the Segway Drift will beep once.
● Power Level Indicator:
There are 4 LED lights, each light has two status:
light on and blink. The status indicates the power
remaining as below.
● Handle:
While the Segway Drift is
powered off, use the
handle to lift and carry.
Status
●●●●
●●●○
●●●
●●○
Power Remaining
Full power
approx. 88%
approx. 75%
approx. 63%
Status
●●
●○
●
○
Power Remaining
approx. 50%
approx. 38%
approx. 25%
＜13%
● Light on ○ Blink
*When the power is too low to ride, the Segway Drift will beep and tilt
back. The power level indicator light will also blink rapidly.
● Glow light:
After the Segway Drift
is powered on, press
and hold the power
button for about 3
seconds to switch on
glow light mode. If
successful, the Segway
Drift will beep once.
04 05

Segway Drift W1 Specifications

General

Charging Time	3 hours
Battery Capacity	44.4 Wh
Tire Type	Solid rubber
IP Rating	IP54
Range	45 minutes
Max Load	100 kg
Net Weight	3.5 kg each