Features
a. There is no front or back of the Segway Drift. You can step on from either direction.
b. When the Segway Drift is in Balance Mode, place one foot on the middle of the mainframe's foot mat. Give gentle pressure
on the front end of the foot mat, the Segway Drift will go forward; give gently pressure on the rear end of the footmat, it will
go backwards.
* If the Segway Drift cannot enter Balance Mode and beeps an alarm, try restarting it. If the problem persists, please contact
after-sales service.
Standby Mode: The Segway Drift
will enter Standby Mode when the
Segway Drift is powered on and
parked on the ground.
Balance Mode: The Segway Drift
will enter Balance Mode when it is
gently touched on the tilted end.
If the Segway Drift does not
detect a rider within 1 minute after
entering Balance Mode, the
Segway Drift will enter Standby
Mode automatically.
c. The Segway Drift is very sensitive. Relax when riding and keep your center of gravity steady.
Do not press the edge of the Segway Drift while in Balance Mode if you are not riding it. Doing so could force the Segway
Drift to move rapidly. It may lead to serious injuries for you or others.
6 Learning to Ride
1. Vehicle Control Practice
a. Turn on one mainframe, put single foot on the middle
of the foot mat, then swing back and forth to feel the
control.
b. Switch to the other foot, then swing back and forth to
feel the control.
3. Stepping On
With assistance from your friend, put one foot on the
middle of the mainframe's foot mat. When comfortable,
stand straight and look straight ahead while stepping up
with your other foot. Try to avoid rocking back and forth.
2. Get Ready
Ask a friend to assist you on your first ride. Go to a
large open area. Place both mainframes shoulder
width apart and put them into Balance Mode.
Wear an approved helmet and other protective
gear to minimize any possible injury.
WARNING
Rider must weigh between 22–220 lbs
(10–100 kg).
06 07
To Next Page
Loading...
Need help?
General
