12
STEP 2: Install the GNSS Antenna
Connect the GNSS antenna to the charging
station.
5 Secure the cable on the pole with the supplied hook and
loop tape.
6
Align the notch on the extension cable (A)
with the groove on the power supply connector (B).
A B
Rotate the other extension tube onto the base fork.
3
Slide in the tube with the antenna.
4
To ensure GPS signal, DO NOT
put anything on the antenna.
Fixate the GNSS antenna on the tube.
1
Turn the nut until they are locked into each other.
STEP 3: Check the GPS Signal
Connect the extension cable with the power supply.
1
2
Unfold the base fork and insert it into the ground.
To Next Page
Loading...
