Seiko 7T84 - Page 11

English
20
English
21
Example: When the restart setting function is activated during the stopwatch
measurement after the 5-minute yacht timer finishes counting
down , and 4 minutes has elapsed since then.
* For the 5 -minute yacht timer, restarts of the stopwatch occur at
5-minute intervals from the start of measurement.
* For the 6-minute or 10-minute yacht timer, restarts of the stopwatch
occur at 6-minute or 10-minute intervals respectively from the start of
measurement.
<Example of use of the restart setting function in racing where the time
from the warning signal to start signal is defined as 5 minutes, and the time
from the start signal to restart signal is defined as 10 minutes>
* The general recall signal is a signal issued when a number of yachts make
false starts or violate racing rules and the race committee is unable to
identify or the starting procedures are incorrect.
* For detailed rules on yacht racing, check the appropriate racing rules of
each race.
u
For actual yacht racing, the restart setting function can be used in 5
minute yacht timer measurements as follows:
Yacht timer starts.
(button A)
Stopwatch starts.
5’00” interval
Elapsed time
Yacht timer operation
Timer
Stopwatch Stopwatch
5’00” interval
5’00” interval
5’00” elapsed
5’00” interval
Stopwatch restarts.
Timer starts from 1’00” to go.
4’00” elapsed
Keep pressing button A
for 2 seconds
(Timer restarts.)
Timer
<5 minutes prior to start>
<4 minutes after start>
Race proceedings
Warning signal
Start signal
General recall signal
Restart signal
Yacht timer starts.
(button A)
Stopwatch starts.
5’00” interval
Elapsed time
Yacht timer operation
Timer
Stopwatch
Timer
5’00”
interval
5’00” interval
5’00” elapsed
Stopwatch restarts.
Timer starts
from 2’30” to go.
7’30” elapsed
Keep pressing button A
for 2 seconds
(Timer restarts.)
Stopwatch