Seiko H024 - Page 23

23
English
*6 Remarks on stopwatch function:
• The lap number counts up to “199”. After “199”, the number is displayed in two digits
such as “00” for 200, “00” for 300, and so on.
• The split number counts up to “199”. After “199”, the number is displayed in two
digits such as “00” for 200, “00” for 300, and so on.
*7 Remarks on memory recall function:
• In memory recall after measurement, the oldest measurement in memory is displayed. In
memory recall during measurement, the newest measurement in memory is displayed.
*8 Remarks on timer function:
• The digits advance quickly if Button D is kept pressed.
• Pressing button A while the digits are flashing can reset the timer to “0:00,” and the
minute digits start flashing.
• If the watch is left untouched in the TIMER SETTING display with an item flashing,
it will automatically return to the TIMER mode in 2 to 3 minutes.
*9 Remarks on alarm function:
• The digits advance quickly if Button D is kept pressed.
• When the time in the TIME/CALENDAR mode is set in the 24-hour display, the alarm
time will also be shown in the 24-hour display.
• When setting the hours in the 12-hour display, check that AM/PM is properly set. “P”
mark appears when the alarm time is set to PM.
• If the watch is left untouched in the ALARM SETTING display with an item flashing,
it will automatically return to the ALARM mode in 2 to 3 minutes.