Seiko V115A - Battery and Circuit Cover Installation

TECHNICAL GUIDE
Cal. V115A

l
Rechargeable battery and electronic circuit
12 
• How to install
Set the “B” portion of the (-) lead terminal
of the rechargeable battery unit to the
groove of the main plate, and then, set the
“A” portion of the (-) lead terminal to the
guide post of the main plate.
Notes:
 
so as not to short-circuit its (+) and (-) terminals.

be deteriorated.
 
it is an electronic part.
Rechargeable battery unit
Guide
post
“A” portion of
the (-) lead terminal
“B” portion of
the (-) lead terminal
   
• How to remove
Remove the two circuit block cover screws,
and then, release the two hooking portions
marked with the arrows in the illustration at
right from the main plate.
• How to install
Set the circuit block cover so that the two
hooking portions marked with the arrows in
the illustration at right catch the main plate
securely, and then, tighten the circuit block
cover screws.