English
English
36 37
Troubles Possible causes
The STOPWATCH hands do not
return to the 0 position when the
stopwatch is reset.
Affected by external sources, or because the
internal IC had been reset, the stopwatch hand
positions have moved out of correct alignments.
The inner surface of the glass is
clouded.
Moisture has entered the watch because the
gasket has deteriorated.
The date changes during the day.
The time is set 12 hours ahead of or behind
the correct time.
Solutions
Adjust the STOPWATCH hands to the 0 position by following the instructions in
“
TIME SETTING AND HAND POSITION ADJUSTMENT
.” (P. 11)
Contact the retailer from whom the watch was purchased.
Reset the time correctly, referring to “TIME SETTING AND HAND POSITION
ADJUSTMENT.”
(P. 11)
• In the event of any other problem, please contact the retailer from whom the watch was purchased.
To Next Page
Loading...
