EasyManua.ls Logo

Seko ProTwin - User Manual

Seko ProTwin
37 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
0000137791 Rev. 4.0
EN
DE
ES
FR
IT
PROTWIN
INSTALLATION MANUAL
HANDBUCH
MANUAL DE INSTALACION
MANUEL D’INSTALLATION
MANUALE D’INSTALLAZIONE

Table of Contents

Questions and Answers

  • R
    Russell PalmerAug 12, 2025
    What to do if Seko Cleaning Equipment product is not mixed or not dosed correctly?
    • H
      hgreenAug 12, 2025
      If the Seko Cleaning Equipment isn't mixing or dosing product correctly, several factors could be at play. Start by checking the foot filter for clogs and clean or replace it if necessary. Inspect the calibration nozzle for blockages, cleaning or replacing it as needed. Ensure your water pressure meets the minimum requirement of 22 PSI; if it doesn't, contact a plumber. Make sure the chemical product container isn't empty and refill or change it if it is. Verify the suction hose is properly connected to the elbow fitting, using a clamp for a secure grip, and ensure the suction hose isn't crimped. Finally, check the venturi for debris or solids, cleaning it with water or compressed air, avoiding tools that could damage it; use anti-lime products to remove lime deposits.
  • D
    Dennis ThomasAug 19, 2025
    How to troubleshoot no flow in Seko Cleaning Equipment?
    • C
      Christian LawsonAug 19, 2025
      If there is no flow in your Seko Cleaning Equipment, start by ensuring the outside tap is open to supply water. Then, select either 'product' or 'rinse' on the equipment. Make sure the spray gun is turned on. After that, check the water supply filter at the input station for any clogs. Finally, inspect the venturi.
  • A
    Alexandra PetersonAug 27, 2025
    What to do if the chemical product container fills with water in Seko Cleaning Equipment?
    • V
      vazquezjulieAug 27, 2025
      If the chemical product container of your Seko Cleaning Equipment fills with water, it's likely that the non-return valve is either clogged or worn. To resolve this, try cleaning the non-return valve. If cleaning doesn't solve the issue, replace the valve.
  • D
    Derrick SmithSep 3, 2025
    Why is the concentration too high with Seko Cleaning Equipment?
    • D
      Dennis OlsonSep 3, 2025
      If the concentration is too high when using your Seko Cleaning Equipment, the nozzle might not be fully inserted, or the wrong metering tip might be in use. Ensure the nozzle is securely plugged into the non-return valve. If the issue persists, select a smaller metering tip.

Seko ProTwin Specifications

General IconGeneral
BrandSeko
ModelProTwin
CategoryCleaning Equipment
LanguageEnglish