Seko ProTwin - Technical Characteristics

0000137791 Rev. 4.0 EN
2
TECHNICAL CHARACTERISTICS:
Water supply
connection
Connection on left side with elbow
Inlet connection type
Male ¾” GHT
Outlet connection type
Male ¾” GHT
Chemical product
channel flow rate
Water supply of 8gal/min flow rate and 45psi: 2.4 gal/min
Rinse channel flow rate
Water supply of 8gal/min at 45psi: 4.2 gal/min
Maximum dimensions
H = 15.75”
L = 13”
D = 6.3”
Working pressure
Min 22 PSI
Max 85 PSI
Optimum: 30 – 60 PSI
Temperature
Max 140°F (60°C)
! PLEASE READ THE FOLLOWING WARNINGS BEFORE INSTALLING OR SERVICING THE
CLEANING STATION
" Make sure that the water supply pressure is between 22 -85 PSI, in case of excessive pressure use a
pressure regulator to avoid breackage.
" Make sure that the water supply temperature does not exceed 140° (60°C)
" The ProTwin’s fittings have been tested with commonly used liquid detergents mixed with water.
" Check that the detergent used is compatible with polypropylene.
" Install the station near as possible to a water supply connection point.
" Mount the ProTwin considering easy access for cleaning and routine maintenance.
# WARNING: Disconnect water supply before servicing the ProTwin.
# WARNING: Follow common safety procedures. Use adequate protection for the eyes, face, hands,
and clothing.
! We constantly work to improve our products and reserve the right to make changes at any time
without prior notice.
! Failure to follow these safety precautions may cause personal injury or damage to the equipment.
! Only use recommended accessories.