Sel 651RA - Wiring Without Fuse Block; Form Drip Loop and Route Harness Wires; Secure Wires on Top of Control Module

SEL-651RA Recloser Control Date Code 20160329
2
Figure 1 Install Ring Terminal
Step 4. If your unit is equipped with the fuse block for field wiring, go
to Wiring With Fuse Block. Otherwise, go to Wiring Without
Fuse Block.
Wiring Without Fuse
Block
Step 1. Form a drip loop and route the harness wires to the left toward
the 14-pin connector. See Figure 2.
Figure 2 Form Drip Loop and Route Harness Wires
Step 2. Join the 8-pin wires with the main harness and route the wires
through the wire loom and up the swing panel hinge through
the existing wire clamps.
Step 3. Route the wires across the top of the control module. The
accessory wires route separately from the main harness.
Step 4. Use the existing nuts to secure the wires to the top of the
control module with the two accessory wire clamps (if they are
not already installed). See Figure 3.