Selec PID500 User Manual

32
DISPLAY CONDITIONDISPLAY DESCRIPTION
Output percentage
Elapsed soak time
Temperature unit
Alarm acknowledge 1
Alarm acknowledge 2
Blank
This parameter is read only and
cannot be altered.
Not e: Th is par ameter is
prompted only if Ramp is ON /
Hold. This parameter is read
only and cannot be altered.
Note: This parameter is not
prompted for 0-10 V / 4-20mA.
This parameter is read only and
cannot be altered.
Not e: Th is par ameter is
prompted only if Alarm1 is ON
and Latch is ON.
Not e: Th is par ameter is
prompted only if Alarm2 is ON
and Latch is ON.
/
Programming

Selec PID500 Specifications

General

Mounting	Panel Mount
Operating Temperature	0 to 50°C
Input Type	Thermocouple, RTD
Control Type	PID, On/Off
Output Type	Relay, SSR
Supply Voltage	85 to 270 VAC
Display	Dual, 4-digit, 7-segment LED
Size	48 x 48 mm
Accuracy	±0.25% of F.S. ±1 digit