Selmo Electronics MUSA Plus Eco - Advanced Functions and Disposal; Key Lock and Open Window Detection; Product Disposal Guidelines

Comfort technologydivisio
n
“MUSA Plus Eco
”
Electronic control for towel radiators
Rev. 0
2
- Sept. 201
7
Selmo Electronic
Viia Pacinotti, 24 - 35030 Rubano (PD) Italy- Tel 049.8976761, Fax 049.8976085 - www.selmo.it
EN
4. KEY LOCK
It is possible to lock the buttons of the device to avoid inadvertent modifications
of the settings.
Press together the [PROG] buttons for 3 seconds to lock all the buttons except
the [On/Stand-by] button. The key-lock icon is activated on the display.
To unlock the buttons press again together the [PROG] buttons for 3 seconds.
The key-lock icon disappears on the display
5.“Open Window Detection” function
The “Open Window Detection” function enables detecting of an open window by sensing a sudden decrease
of the temperature in the room. In such a case, the device deactivates the heating element for a maximum of
30 minutes or until an increase of the room temperature reveals that the window has been closed.
To activate this function:
Enter into “Stand-by” mode.
Press the [+] button for 3 seconds.
Press the [+] button to activate / deactivate the function
Press the [Prog] button to commit and return into “Stand-by” mode.
When this function is enabled, the “Open Window” icon on the display is lit.
When the device detects that the window is potentially opened, the “Open Window” icon starts blinking
When the function is disabled the “Open Window” icon is not shown on the display.
Note: The device could fail in detecting an opened window e.g. if the thermostat is located on an isolated area
of the room and far from air currents or if the thermostat is placed close to an external heating source, or if the
temperature variation in the room is too slow.
Note 1: When the symbol " " is on, the heating element is active.
The manufacturer reserves the right to make any changes to the product described in this manual,
at any time, and without prior warning.
DISPOSAL
This product may not be treated as ordinary household waste. It has to be disposed in
proper waste collection sites. In case of replacement it shall be returned to the
distributor. Such an end-of-life treatment of the product will preserve the environment
and will reduce consumption of natural resources. This symbol applied to the present
product indicates the obligation to bring it to a proper waste collection site, in order to let
it be disposed according to 2002/96 / CE (RAEE - WEEE) directives.