Sena 50S - VOX Intercom; Bluetooth Intercom Audio Multitasking

50S Motorcycle Bluetooth
®
Communication System with Mesh Intercom™ | 62
14 CONFIGURATION SETTING
14.2.8 VOX Intercom (Default: Disable)
If VOX Intercom is enabled, you can initiate an intercom conversation
with the last connected intercom friend by voice. When you want
to start intercom, say a word such as “Hello” loudly or blow air into
the microphone. If you start an intercom conversation by voice, the
intercom terminates automatically when you and your intercom
friend remain silent for 20 seconds. However, if you manually start an
intercom conversation by tapping the Jog Dial, you have to terminate
the intercom conversation manually. However, if you start the intercom
by voice and end it manually by tapping the Jog Dial, you will not be
able to start intercom by voice temporarily. In this case, you have to
tap the Jog Dial to restart the intercom. This is to prevent repeated
unintentional intercom connections by strong wind noise. After
rebooting the headset, you can start the intercom by voice again.
14.2.9 VOX Sensitivity (Default: 3)
Vox Sensitivity can adjust the sensitivity of Vox Phone and Vox
Intercom. Level 5 is the highest sensitivity setting and level 1 is the
lowest.
14.2.10 Bluetooth Intercom Audio Multitasking
(Default: Disabled)
Audio Multitasking (Bluetooth Intercom Audio Multitasking and
Mesh Intercom Audio Multitasking) allows you to have an intercom
conversation while simultaneously listening to music, FM radio, or
GPS instructions. The overlaid audio is played in the background with
reduced volume whenever there is an intercom conversation and will
return to normal volume once the conversation is finished.
The Mesh Intercom Audio Multitasking feature is always on.
Note:
• For Bluetooth Intercom Audio Multitasking to work properly, you
need to power the headset off and on. Please restart the headset.
• Bluetooth Intercom Audio Multitasking will be activated during
two-way intercom conversations with a headset that also supports
this feature.
• Some GPS devices may not support this feature.
• The Audio Multitasking feature can be configured through the
Intercom-Audio Overlay Sensitivity and the Audio Overlay
Volume Management settings.