Latitude SR Smart Snow Helmet | 6
1 ABOUT THE LATITUDE SR SMART SNOW HELMET
1.4 Wearing the Helmet
1.4.1 How To Fit the Helmet
For proper use, the helmet must sit level on the head and low on
the forehead. The helmet uses a simple, quick-release buckle system
that, once adjusted, can be buckled and unbuckled without changing
the adjustment. For proper use, the straps must be tight and evenly
tensioned.
To properly wear your helmet:
1. Position the helmet on your head with the front covering your
forehead. If the helmet is tipped back and is not covering your
forehead then the helmet is not in the proper position.
2. Position the strap adjuster centered, just below your ears.
WARNING: Always wear the helmet in the proper position on
your head with the front of the helmet covering your forehead for
maximum protection. Never wear the helmet tipped back as the
helmet will be in the improper position causing your forehead to be
exposed. All fitment adjustments need to be made with the helmet
in the proper position.
3. Position the helmet low on your forehead with the buckle under the
chin and back against the throat. The straps should fit comfortably
around both ears.
4. With the strap adjuster in the proper position, adjust the chinstrap
tension at the buckle. Adjust the tension so the chinstrap is tight
and comfortable by pulling the chinstrap end through the buckle
to either tighten or loosen as needed. Always wear the helmet with
the chinstrap buckle fastened and the chinstrap pulled tight and
positioned back against the throat. With the strap buckled and
the helmet positioned, you should feel the chinstrap pull firmly
against your chin as you open your mouth. When properly adjusted
the helmet will wrap around your head and cradle it with firm, but
comfortable pressure.
To Next Page
Loading...
