Sena SPH10H - Enabling;Disabling Voice Prompts; Enabling;Disabling Sidetone; Delete All Bluetooth Pairing Information; Exit Voice Configuration Menu

SPH10H
20
9.4 Enabling/Disabling Voice Prompts
Voice Prompt
“Voice prompt”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
You can disable voice prompts by configuration setting,
but the following voice prompts are always on.
- Voice prompts for configuration setting menu
- Voice prompts for battery level Indicator
- Voice prompts for factory reset
9.5 Enabling/Disabling Sidetone
Voice Prompt
“Sidetone”
Factory Default Disable
Enable Tap the Phone Button
Disable Tap the Jog Dial
Sidetone is the sound of your own voice as picked
up by your headset’s microphone and reproduced
in your own ear, by your own speaker. It helps you
to naturally speak at the correct level according to
varying helmet noise conditions. If this feature is
enabled, you can hear what you are speaking during
an intercom conversation or a phone call.
9.6 Delete all Bluetooth Pairing Information
Voice Prompt
“Delete all pairings”
Factory Default N/A
Execute Tap the Phone Button
To delete all Bluetooth pairing information of the
SPH10H, rotate the Jog Dial until you hear a voice
prompt saying “Delete all pairings”, and tap the
Phone Button to confirm. Taping the Jog Dial is not
available for this setting.
9.7 ExitVoiceCongurationMenu
Voice Prompt
“Exit conguration”
Factory Default N/A
Enable Tap the Phone Button
To exit voice configuration menu and get back to
stand-by mode, rotate the Jog Dial until you hear a
voice prompt saying “Exit conguration”, and tap
the Phone Button to confirm. Tapping the Jog Dial is
not available for this setting.