1. It is important to note that pedals are sided. Remember, this is
always from the perspective of the rider. Locate the left-hand
side/right-hand side pedal, which is marked "L" and "R".
2. The thread on the left-hand pedal is reversed, so tighten it
counterclockwise. Install the left-hand pedal into the left crank
arm gently by hand, then tighten the pedal with a 15mm wrench.
3. The right-hand pedal has a normal thread, so tighten it
clockwise. Install the right-hand pedal into the right crank arm
gently by hand, then tighten the pedal with a 15mm wrench.
Adjusting the Seat Position and Angle
To change the angle and horizontal position of the seat:
1. Use a 6mm Allen wrench to loosen the seat adjustment bolt on
the clamp positioned underneath the seat, above the rear wheel.
Do not fully remove the bolt.
2. Move the seat backward or forward to adjust the angle. A seat
position horizontal to flat ground is desirable for most riders.
3. While holding the seat in the desired position, use a 6mm Allen
wrench to tighten the seat adjustment bolt securely to the
recommended torque value.
Rear Rack and Taillight
1. Remove the screws and washers from the bike. Align the holes
on the rear rack with the holes on the frame. Place some soft
foam under the rear rack to prevent it from scratching the fender
during installation.
2. Insert the washers and screws through the holes and into the
frame. Tighten all screws with the appropriate tool.
To Next Page