1. To remove the battery, first insert the battery key into the
keyhole. Turn the key counterclockwise to unlock. Slide the
battery forward and upward to remove it.
2.
Carefully slide the battery into the battery holder on the frame.
Turn the key clockwise to lock the battery onto the frame, then
remove the key and keep the key in a place you always remember.
NOTE:
1. Before each use, lock battery and remove the key. If the lock
does not lock up or the key cannot be removed, the battery has
not been properly installed. Please remove the battery and install
it again.
2. When removing the battery, turn the key counter-clockwise to
unlock. slide the battery upwards and lift it off the frame.
3. When the battery is removed, be careful not to drop or damage
it. Avoid damaging the exposed connector terminals and keep
them clear of debris or water.
4. Do not force the battery into the battery holder. Slowly align
and push the battery down into the battery holder.
5. Ensure the battery has been properly secured to the bike before
each use. Carefully pull upwards on the battery with both hands to
test the security of its attachment to the mount.
6. Keep the keys properly. If the unique keys are lost, you will not
be able to lock/unlock the battery. It is recommended to store two
keys separately. If necessary, you should get more spare keys. We
cannot guarantee the provision of a backup key.
Charge Your E-Bike
1. The battery can be charged while attached or detached from
the bike. To remove the battery, see the previous "Remove
Battery" section for details. You should plug your battery in when
you first receive it to ensure it is fully charged prior to your first
ride.
2. Remove the rubber cover on the charging port on the right side
To Next Page