SENADA ARCHON PLUS - Error Codes

28
Error Codes
Error Code
Meaning
Most Common Solution
Error 001
Controller failure
Check the cable harness
connection of the controller or
replace the controller with a
new controller
Error 002
Communication failure
Check that the cable connectors
are properly connected and the
pins in connectors are good
Error 003
Hall failure
Check if the motor cable is
damaged. Check whether the
connector of the motor cable is
loose and the pins are good
Error 004
Throttle failure
Check if the throttle rebound is
good, if the connector of
throttle cable is properly
connected and the pins in
connector are good
Error 005
Brake sensor is
engaged
（
Brake light is
always on when the
display is on
）
Check if the brake levers
rebound to normal position.
Disconnect the connector on
each side of the sensor wire to
check if the Error 005
disappear. Loose screws under
the brake sensor and move the
sensor pad a little bit away
from the brake lever.
Error 006
Motor phase failure
Check if the motor cable is
damaged. Check whether the
connector of the motor cable is
loose and the pins are good