To Next PageTo Next PageWhat to do if Senco Power Tool has air leak near bottom?
If you notice an air leak near the bottom of your Senco Power Tool or experience poor return, try cleaning the tool. Alternatively, tighten the screws or install Repair Kit B.
General| Category | Power Tool |
|---|---|
| Power Source | Pneumatic |
| Operating Pressure | 70 - 120 psi |
| Width | 2" |
| Air Inlet | 1/4" NPT |
| Exhaust | Rear |
Instructions for loading staples into the tool's feeder mechanism.
Details on dual-action trigger operation for driving fasteners.
Explains the single-action trigger mode for precise fastener placement.
Procedure to adjust the depth control for driving fasteners.
Step-by-step guide for safely removing jammed staples from the tool.
Important warnings regarding tool repairs and screw tightness.
Daily checks for trigger and safety element movement.
Instructions for oiling the air inlet and cleaning the tool.
Details on parts and conditions not covered by the warranty.
Conditions required for warranty honor and limitations.
Policy for replacing tools destroyed by acts of nature.
Information on product returns for customer satisfaction.
