Why is my Senco SCN200 drive weak?
If your Senco Tools are not driving fasteners with sufficient force, ensure that the air supply is adequate. If the issue persists, consider installing Parts Kit C.
What to do if my Senco Tools are jamming?
If your Senco Tools are jamming, try cleaning the tool and lubricating the magazine. If the problem continues, consider installing Parts Kit D.
How to fix poor feed on Senco SCN200 Tools?
If your Senco Tools are not feeding properly, you should clean the tool, lubricate the magazine, or consider installing Parts Kit D.
How to fix air leak near the bottom of Senco SCN200 Tools?
If your Senco Tools have an air leak near the bottom, try tightening the screws. If that doesn't solve the problem, install Parts Kit B.
Why is my Senco Tools operation sluggish?
If your Senco Tools are operating sluggishly, consider installing Parts Kit A.
How to fix air leak near the top of Senco SCN200?
If your Senco Tools have an air leak near the top, tighten the screws. If the issue continues, install Parts Kit A.
What to do if Senco Tools does nothing?
If your Senco Tools are not working, verify the air supply. If that's not the issue, install Parts Kit A.
How to replace broken or worn driver in Senco SCN200?
If your Senco Tools have a broken or worn driver, install Parts Kit C.
What to do for poor return on Senco Tools?
To address poor return in your Senco Tools, you can clean the tool or install Parts Kit B.
General| Nail Size | 2" to 3-1/4" |
|---|---|
| Operating Pressure | 70 - 120 psi |
| Battery | No |
| Fastener Gauge | 0.113" - 0.131" |
| Fastener Length | 2" - 3-1/4" |
| Air Inlet | 1/4" NPT |
To Next Page
