What to do if my Senco SLS20 Staple Gun is jamming?
If your Senco Staple Gun is experiencing a poor feed or jamming, you should try cleaning the tool, lubricating the magazine, or installing Parts Kit D.
How to fix air leak near top of Senco SLS20?
If you notice an air leak near the top of your Senco Staple Gun or experience sluggish operation, verify the air supply and tighten the screws, or install Parts Kit A.
What to do if Senco Staple Gun has air leak near bottom?
If you notice an air leak near the bottom of your Senco Staple Gun or experience poor return, clean the tool and tighten the screws, or install Parts Kit B.
Why my Senco SLS20 has weak drive?
If your Senco Staple Gun has a broken or worn driver or weak drive, verify adequate air supply or install Parts Kit C.
Employer's duties for safe tool operation and manual availability.
Addresses symptoms of air leaks or sluggish tool performance.
Addresses symptoms of poor feed or tool jamming.
Addresses symptoms of a broken or worn driver.
Detailed technical data and measurements for each stapler model.
List of available accessories for SENCO tools.
Details the warranty period, coverage, and conditions for tool and parts.
Procedure for replacing tools destroyed by natural disasters.
Employer's duties for safe tool operation and manual availability.
Addresses symptoms of air leaks or sluggish tool performance.
Addresses symptoms of poor feed or tool jamming.
Addresses symptoms of a broken or worn driver.
Detailed technical data and measurements for each stapler model.
List of available accessories for SENCO tools.
Details the warranty period, coverage, and conditions for tool and parts.
Procedure for replacing tools destroyed by natural disasters.
General| Length | 12.5 inches |
|---|---|
| Staple Gauge | 20 gauge |
| Operating Pressure | 70-120 psi |
| Air Inlet | 1/4 inch NPT |
| Power Source | Pneumatic |
| Fastener Type | Staple |
| Staple Crown | 1/4 inch |
| Staple Length | 1/2 inch to 1-1/2 inches |
To Next Page
