To Next Page
J
Jill DorseyJul 30, 2025
What to do if my Senco SFW10XP is jamming?
- SstephenandersenJul 31, 2025
If your Senco Staple Gun is jamming, you should clean the tool, lubricate the magazine, or install Parts Kit D.
What to do if my Senco SFW10XP is jamming?
If your Senco Staple Gun is jamming, you should clean the tool, lubricate the magazine, or install Parts Kit D.
How to fix an air leak near the top of my Senco Staple Gun?
To fix an air leak near the top of your Senco Staple Gun, verify the air supply and tighten the screws, or install Parts Kit A.
What to do if there is an air leak near the bottom of my Senco Staple Gun?
If there's an air leak near the bottom of your Senco Staple Gun, clean the tool, tighten the screws, or install Parts Kit B.
Understand safety warnings to prevent injuries to yourself and others.
Operate tool safely, pointing away from people, at lowest pressure.
Safety warning against using faulty or leaking tools.
Action to take if a staple jam occurs: disconnect air supply.
Safety and operational guidelines for tool use, including air pressure.
Initial steps for maintenance: disconnect air, empty magazine, read safety warnings.
Daily inspection of safety element and trigger for free movement while tool is disconnected.
Warning about authorized personnel for repairs not covered in the manual.
Air leaks, sluggish operation, poor return, weak drive, jamming issues.
Operating pressure range and air consumption for different tool models.
Air inlet size, maximum speed, and weight specifications for each tool model.
Staple capacity and overall dimensions (height, length, width) for each tool.
General| Magazine Capacity | 100 staples |
|---|---|
| Fastener Type | Staples |
| Fastener Gauge | 18 gauge |
| Operating Pressure | 70-120 PSI |
| Air Inlet | 1/4" NPT |
| Type | Pneumatic |
| Power Source | Pneumatic |
| Staple Size | 1/4 inch to 9/16 inch |
| Fastener Length | 1/4 inch to 9/16 inch |
