Sencor 3CAM 5200W - Battery Charging

6 EN
EN
Revision 05/2015Copyright © 2015, Fast ČR, a. s.
Start-up
A. Use your fi ngernail to gently push the fl exible battery compartment closure and open
the cover.
B. Insert the battery completely into the camera battery compartment (with the contacts
aligned). Make sure the removal tongue remains accessible.
C. The camera will activate if the battery is charged enough.
D. Place the battery compartment cover back on the camera (in the direction towards the
side of the camera) and gently close the cover until the fl exible closure clicks.
E. Battery removal: open the cover and pull on the tongue to remove the battery.
Tip: anew battery reaches full capacity after about 3 charging cycles. We recommend
fully charging the battery (until the red indicator goes off) and is deplete until the camera
switches off. This extends the battery life.
Note: the camera can be operated even without abattery with an external power supply,
for example in the car. Unexpected states can occur with alow battery inserted, including
spontaneous shutdown. Charge the camera battery at least alittle when using the camera
for the fi rst time.
3.3. Charging
The inserted battery can be charged either by connecting the camera to acomputer or
using apower adapter. The adapter must supply an output voltage of 5 Vand can either be
anetwork adapter or car adapter. Prior to connecting the power adapter, make sure its voltage
is compatible with the network voltage, or voltage supplied by the vehicle.
st 3CAM 5200W SENCOR EN CZ SK PL HU.indb 6 4.5.2015 18:45:5