Sencor 3CAM 5200W - Camera Power and Mode Switching; Recording Videos and Taking Photos

EN 7
EN
Revision 05/2015Copyright © 2015, Fast ČR, a. s.
Start-up
The camera can be charged in both on and off states. Recordings can be made during the
charging process (e.g. in the car). The charging indicator is on while charging (top, left). The
adapter, battery and camera become slightly warm while charging. This is anormal effect of
energy conversion.
3.4. Switching the camera on and off
A. Press and hold the switch for 3 to 5 seconds to switch the camera on or off. Ablue
indicator (bottom, left), or active display (based on the current settings: PowerSave)
indicate the camera is on.
B. The camera also switches on and off (based on the current settings, see further) by
connecting and disconnecting the power supply, for example in the car, according to the
ignition key position.
C. The camera can also be confi gured to automatically start based on its internal motion
detectors and shut down after aconfi gurable delay.
3.5. Switching between modes
Press the on/off switch shortly to switch between modes: Video Recording / Camera /
Playback / Settings.
The mode is indicated by the following symbols in the top left corner of the active display:
Video/Camera/Play(triangle)/Tools.
3.6. Recording videos and taking photos
Recording (Video Recording mode) and taking photos (Camera) is possible if amemory card is
inserted into the camera and properly formatted. This can easily be achieved by pressing the
OK on the top of the camera when the display is on. If the display off (PowerSave), the fi rst
press of the button activates the display and the second press performs the desired function.
To stop an active recording process, press OK again when the display is on.
st 3CAM 5200W SENCOR EN CZ SK PL HU.indb 7 4.5.2015 18:45:5