Sencor 3CAM 5200W - 6. Camera Settings

EN 11
EN
Revision 05/2015Copyright © 2015, Fast ČR, a. s.
Camera settings
Note: pairing the camera and mobile phone is atwo-way operation; once the mobile
phone is connected, you cannot connect to another mobile phone, so you have to unpair
the fi rst phone. Phones running Android 2.3 or higher and iOS are supported.
The transmitted picture is slightly delayed compared to reality. The Wi-Fi connection
range depends on the surrounding environment (interference etc.). Astrong signal ensures
areliable data transmission. You can track the signal indicator in the ispocam application.
The data transmission can oscillate or controls or transmission can be completely
impossible with aweak signal.
NOTICE: the camera still respects the PowerSave settings. If you have an Off
interval set, the camera will shutdown when this interval is reached and the
connection will be lost. The procedure above (from item 2) shall be repeated to
restore the connection.
6. Camera settings
The camera can operate in many modes and its settings are adapted to do so. Before fully
using your camera, take the time to properly confi gure and test your camera. This way you
can prevent disappointment with the fi nal product not meeting your expectations. You should
particularly consider whether or not the camera will be moving during the recording process,
how long the recording will be, how the camera will be powered, etc. Also consider possible
confl icts in processing impulses (spontaneous activation, motion detection, delay shutdown,
connecting the power supply to charge the battery) to avoid missing the events you would
like to capture because one impulse was not followed by the second.
st 3CAM 5200W SENCOR EN CZ SK PL HU.indb 11 4.5.2015 18:45:5