Sencor 3CAM 5200W - Page 14

12 EN
EN
Revision 05/2015Copyright © 2015, Fast ČR, a. s.
Camera settings
Press Up and Down to switch between items, press OK to enter the menu item. Select the
desired value within the menu item and press OK to save this value and close the item. Press
Mode to exit Settings by switching to adifferent mode.
Note: the individual settings have symbols mentioned by their names. The same symbol
appears on the status display.
1. Movie Size – indicated by anumber on the display
Choose between FHD 1080p and HD 720p. Remember that both cases require having
amemory card that is fast enough to write the received data. The amount of data and
fi le sizes for 1080p is larger than 720p.
2. Seamless – camera symbol with 1/3/5 on the display
Chose afull recording (OFF) or divided into individual 1 min/3 min/5 min fi les. Use the
division feature especially in cases where fi le lock is used (auto-delete protection), e.g.
the impact G-sensor. Smaller fi les are more suitable to lock.
3. HDR – [HDR] symbol on the display
High-dynamic-range imaging is an adaptive shooting technique in ahigh dynamic
brightness range, which is supposed to give acloser sense of human perception. For
subjectively better results, select On/Off with respect to the lighting conditions and action
speed.
4. Motion Detection – the symbol will appear on the display during the recording sequence
The camera evaluates motion in the viewing angle and activates the recording sequence
if more signifi cant motion is registered. About a10 minute recording is created.
st 3CAM 5200W SENCOR EN CZ SK PL HU.indb 12 4.5.2015 18:45:5