Sencor 3CAM 5200W - Page 15

EN 13
EN
Revision 05/2015Copyright © 2015, Fast ČR, a. s.
Camera settings
5. Record Audio – enabled or disabled microphone symbol on the display
Enable or disable audio recording with picture.
6. Date stamp
Enable or disable including the date and time directly in your recording.
7. Sport Mode – [P] symbol on the display
This mode is automatically activated when the camera experiences aswift movement or
impact. Select the motion intensity sensitivity option LOW, MID, HIGH or OFF to disable
the mode. As soon as the motion detector of acamera that is switched off registers
aswift movement or impact (based on the settings), the camera turns on and records
until the battery runs out of power. For example, this mode can also be used in aparked
car in your absence – Parking mode.
8. G-Sensor – key symbol on the display throughout the duration of recording the currently
locked fi le
The impact sensor locks fi les to protect them against auto-deletion. The camera records
to the memory card until the full capacity of the card is reached. Then it begins to
automatically delete the oldest recordings. For example, locking afi le using the G-sensor
prevents deleting afi le that was recorded immediately before and directly after an
accident, even though the camera were to continue recording. Select the proper sensor
activation threshold (sensitivity) between OFF, LOW, MID, HIGH, which approximately
corresponds to 1G/2G/8G.
st 3CAM 5200W SENCOR EN CZ SK PL HU.indb 13 4.5.2015 18:45:5