Sencor SAC MT9020C - Page 3

07/2019
- 3 -
Copyright © 2019, Fast ČR, a.s.
■ Before connecting the appliance to apower socket, check that the rated
voltage on its rating label matches the electrical voltage in the power socket.
■ The installation must be performed in accordance with the installation
instructions. Incorrect installation may cause leakage of water, electric shock
or fire.
■ To reduce the risk of fire or electric shock, do not use this appliance with any
solid-state speed control device.
■ The appliance must be installed in accordance with the internal national
regulations of electro-installation.
■ Connect the appliance only to aproperly grounded socket. In case the socket
that you are intended to use is not properly grounded or it is not protected
by acircuit breaker or fuse with atime delay (type of fuse/circuit breaker is
determined by maximum unit current. Maximum current is indicated on the
rating label which is located on the unit), ask aqualified electrician to install
the correct socket.
■ Use this appliance only for the purposes described in this user´smanual.
■ The power socket must be freely accessible so that it is possible to quickly
disconnect the power cord from the power source if necessary.
■ The appliance is designed for use at home, in offices and similar types of areas.
Do not use it in very dusty or humid rooms such as laundries or bathrooms,
in areas where chemical or explosive substances are stored, in industrial
surroundings or outdoors!
■ Do not place the appliance in the vicinity of an open flame or appliances that
are sources of heat.
■ Do not place the appliance on unstable surfaces such as carpets with very
long and thick fibres.
■ The appliance may only be used on adry, stable, smooth and horizontal surface.
Otherwise it may cause damage or extreme noise and vibration.
■ The appliance is equipped with travel wheels so pay extra attention when
handling it so that it does not fall down stairs or travel down from sloped areas.
If necessary secure the wheels using the stoppers.
■ Only use original parts to assemble the appliance. Before starting to assemble
the appliance, make sure that it is turned off and disconnected from the power
socket.
■ Use only accessories and parts that are delivered with the appliance and tools
explicitly intended to installation. Using of non-standard parts and accessories
may cause leakage of water, electric shock, fire, injury or damage on property.