07/2019
- 4 -
Copyright © 2019, Fast ČR, a.s.
■
DO NOT adjust the length of the unit´spower cord, do not use extension cord
to power the unit.
■
DO NOT plug the unit into the power socket where other electric appliances are
already connected. Incorrect choice of supply may cause fire or electric shock.
■
Do not cover the power cord by acarpet. Do not place carpet, batten or other
covering on the power cord. Do not place the power cord under furniture or
appliances. Place the power cord on places where nothing can run it over or
drive it.
■
Prior to connecting appliance to apower socket, make sure that the appliance
is correctly assembled according to the instructions in this user’smanual.
■ Do not touch the appliance with wet or damp hands. This applies especially
when it is connected to apower socket.
■
Do not expose the appliance to dripping or spraying water or submerge it
in water or another liquid. Otherwise, immediately unplug the unit from the
power socket.
■
Do not cover or insert anything into the air inlet or air outlet openings.
Otherwise, this could damage the appliance.
■
During operation there needs to be sufficient space for air circulation of at
least 30 cm on all sides of the appliance.
■ Do not expose yourself to acold air current for along time. This could have
anegative effect on your health.
■
To turn the appliance on or off, always use the appropriate buttons on
the control panel or the remote control. Do not turn off the appliance by
disconnecting the power cord from the power socket.
■
Always turn off the appliance and disconnect it from the power socket
when leaving it without supervision, when not using it and before moving,
disassembling or cleaning it.
■ Do not attempt to remove the outer case of the appliance.
■
Disconnect the appliance from the power socket by pulling on the plug, never
pulling on the power cord. Otherwise, this could damage the power cord or
the socket.
■ In the event that the power cord or power plug are damaged in any way, do
not use the appliance.
■ Store the appliance in avertical position. It may be transported in avertical
position or tilted on the sided. If you have already used the appliance, check
that all the condensate has been drained. After transporting it, wait at least
1hour before using the appliance.
To Next Page
