EasyManua.ls Logo

Sencor SIR 5000WDB - Page 16

Sencor SIR 5000WDB
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 EN
EN
Copyright © 2017, Fast ČR, a.s. Revision 09/2017
WLAN connection
can’t be established
1. Check the avaiability of WLAN network
on the access point.
2. Place the device closer to the router.
3. Make sure the WEP/WPA password is
correct.
No station is found. 1. Check the network as well as the access
point and fi rewall.
2. The station may not be avaiable currently,
try it again later or select another station.
3. The link of the station is changed or the
station no longer transmits – ask the radio
station provider for more information.
4. The link of manual added station is not
correct, make sure it is correct and
re-enter.
Alarm does not work. 1. Switch on the alarm.
2. Due to the volume setting, refer to the
solutions of “ No sound”.
3. The source of alarm was set to be station
but there is no network connection.
Change the source of alarm or reconfi gure
the connection.
Unable to do DLNA
streaming.
1. Check the connection of the network.
The device and your PC or mobile device
need to be in the same network, and test
if the nework in good condition.
2. Make sure the settings on your device are
correct.
System freezes
suddently.
1. The radio is overloaded, reboot the unit.

Related product manuals