Sencor SIR 5000WDB - With Remote Control

10 EN
EN
Copyright © 2017, Fast ČR, a.s. Revision 09/2017
The number of bars in the wireless symbol in front of the network
name (SSID) shows the relative signal strength of the network.
The key symbol indicated that the network is password-protected.
If the device does not fi nd any wireless networks, no wireless
Networks Found appears on the display. Change your location,
if necessary, and check your WLAN router.
You can fi nd the SSID of your Access Point in the confi guration
of the Access Point (router).
Select your network and confi rm with OK. If your WLAN
is password-protected, you will be prompted to enter your password.
Enter the password using the number and letter buttons of the
remote control or enter it directly on the device (you can rotate the
Volume/Navigate reel on the top of the device to choose the code).
If it is accidentally pressed > to set anumber/letter, you can press
< to correct the record.
Note the use of upper and lower case when entering the password.
With Remote Control
The cursor indicates the current entry space.
Press the corresponding number button repeatedly:
0 0
1 (space and special symbols)
2 AB C ab c
3 D E F d ef
4 G H Ig h i
5 J KL j kl
6 M N Om n o