Sencor SPT 5280 - Modern Connectivity and Playback; USB Media Playback; Bluetooth Audio Streaming

EN - 8
RANDOM PLAY
Press the PROG./P-MODE button on unit or press MEM/PROG./P-MODE key on remote control in play
mode till the “RAN” shows steady on the display, the random play will start from next track automatically,
until all tracks are played over and then it will stop. Press the PROG./P-MODE button on unit or press
MEM/PROG./P-MODE key on remote control again until the “RAN” disappears from the display to
cancel.
USB OPERATION
1. Press the FUNCTION button on unit or on remote to select “USB” mode.
2. Connect the USB to the USB INPUT. The LCD will show the total number of tracks stored in the
USB. The playback stars from track 1 automatically after reading the USB.
3. Press the MO/ST./ button on unit or on remote to stop playing. The display will show total
number of USB and STOP.
4. Proceed repeat play (repeat 1- repeat folder - repeat all)/program play/skip up and back operation
as the same described in above “CD/MP3 OPERATION”.
CAUTION:
● Do not use any USB extension cable for connecting the USB bar which may cause harmful
interference
BLUETOOTH OPERATION
1. Press the FUNCTION button on unit or FUNCTION key on remote control to switch to
BLUETOOTH function, the LCD will display “ PAIRING ” and the light will fl ash at high speed.
2. Turn on the Bluetooth function on the device, scan the unit “SPT 5280” and connect, then input
the password 0000 if required, the light will light up to indicate connection done, and the display
will show “BLUETOOTH”. Press Play to start playback. If the unit can’t connect the relative
Bluetooth within 2 minutes, the indicator light will fl ash each 2’nds. Then press the SET/PAIR/
ID3 button on unit or on remote control to reconnect.
3. Rotate the VOLUME knob on unit or VOLUME UP/DOWN key remote control or the device to
your desired level.
4. Press the SET/PAIR/ID3 button on unit or ID3/PAIR key on remote control to disconnect
Bluetooth.
Note: The Bluetooth works best within 10 meters.
AUX OPERATION
1. Press the FUNCTION button to select “AUX” mode.
2. Insert the AUX line plug into the AUX IN jack(Φ3.5mm) on the player, music from the device
would be amplifi ed and exported from the speakers.
3. Adjust the volume of the main unit to your desired level.
4. Press PLAY of the external audio source (eg. MP3 player) to start playback.