Sencor SPT 5280 - Radio Memory and Disc Playback; Loading and Playing CDs;MP3 s

EN - 6
RADIO STATION MEMORY OPERATION
You may pre-store 20 (FM ) radio stations in memory for your preference controlled by remote handset,
so as you can listen to your desired station directly and quickly, no need to tuning and search for again.
1. Press FUNCTION button to FM mode.
2. Press MEMORY button on unit or press MEM/PROG./P-MODE key on remote, “P01 ” will fl ash
on the display. Then press the “TUN+/“ or „TUN-/“ button to select the fi rst desired
station.
3. Press the FOLD./10/M+ or FOLD./10/M- button unit or - MEM/FOLD./10 + on remote to choose
the desired sequence you want to store, then press MEMORY button on unit or press -MEM/
PROG./P-MODE+ key on remote again to enter.
4. Search another station, repeat steps (2) & (3) until all desired stations stored. Up to 20 stations
can be programmed.
5. Press the FOLD./10/M+ or FOLD./10/M- on unit or MEM/FOLD./10 UP/DOWN button on remote
to listen to the stored station directly.
CD/MP3 OPERATION
Discs for Playback
This system can playback all digital audio CD/MP3, fi nalized digital audio CD-Recordable (CD-R) discs,
fi nalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital audio CD/CD-R/CD-RW
discs.
LOADING A DISC
1. Press the FUNCTION button on unit or remote control to select “CD” mode.
2. Press the OPEN/CLOSE button to open the CD door, “OPEN” will be shown on the display.
3. Place an audio CD/MP3 DISC into the tray with the front side facing up.
4. Close the CD door.
The display will show a fl ashing “ -- READING -- ”, then the total number of tracks would be
shown and the playback will start from track.
5. To remove the CD, press OPEN/CLOSE to open CD door, the display will show “OPEN ”. Hold
the CD by its edges, and take it out carefully.
Note:
● Make sure the disc is stopped before opening the CD DOOR.
● To ensure good system performance; wait until the unit completely reads the disc before
proceeding.
● If no disc loaded into the tray, or the disc is unreadable, the display will show “NO dISC”.
PLAYING A DISC
1. The playback starts from track 1 automatically when reading the disc.
To pause playback, press  button on unit or on remote. The current playing time will fl ash on
the display.
To resume playback, press  button on unit or on remote again.
2. To stop playback, press MO/ST./ button on unit or on remote, the total number of tracks.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the TUN+/ or TUN-/ button on unit or remote respectively in stop mode or during playing
until the desired track appears on the display. Press the  button on unit or on remote to start play.