EasyManua.ls Logo

Sencor SPT 5280 - Introduction and Safety Precautions; Important Safety Warnings

Sencor SPT 5280
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 1
IMPORTANT: Please read before using and keep for future reference.
INTRODUCTION
Thank you for buying this product.
Please read through these operating instructions, so you will know how to operate your
equipment properly. After you nished reading the instructions manual, put it in a safe place for
future reference.
CAUTION
Use of controls or adjustment or performance of procedures other than those speci ed herein may result
in hazardous radiation exposure.
DANGER
CLASS 1
LASER PRODUCT
This Compact disc player is classi ed as a Class 1 LASER
PRODUCT. THE CLASS 1 LASER PRODUCT label is
located on the rear exterior.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modi cations.
Avoid installing the unit in locations described below:
1. Places exposed to direct sunlight or close to heat radiating appliances such as electric
heaters, or other equipments that radiate too much heat.
2. Places subjected to constant vibration.
3. Unventilated or dusty places.
4. Humid or moist places.
Operate buttons and switches as instructed in the manual.
Before turning on the power for the rst time, make sure that the power cord is properly installed
and the voltage switch is correctly set.
Store your CD or other devices in a cool area to avoid damage from heat.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO DOT REMOVE COVER (OR BACK). DO NOT
OPEN THE UNIT ANY SERVICING PLEASE REFER TO QUALIFIED SERVICE PERSONNEL.
WARNING:
Remove batteries if exhausted or if they will not be used for a long period.
The incorrect use of batteries can cause electrolyte leakage and will corrode the compartment
or cause the batteries to burst. Therefore:
Do not mix battery types, e.g. alkaline with zinc carbonate.
When inserting new batteries, replace all batteries at the same time.