Sencor SVC 900 - Replacing the Inlet Foam Filter; Replacement of the Inflow H.E.P.A. Filter; Replacement of the Outflow H.E.P.A. Filter

Vacuum Cleaner 2 in 1 (bag & bagless)
SVC 900
EN
EN-9
Copyright © 2019, Fast ČR, a.s. Revision 08/2019
Replacing the inlet foam lter
Note:
The input plastic foam lter is only used when using the mode with the dust bag! When not
using the dust bag a dust container is inserted in the grooves in front of the motor and so it is not
possible to use a lter.
The input plastic foam lter is only used when using the mode with the dust bag! When not using the dust bag
a dust container is inserted in the grooves in front of the motor and so it is not possible to use a lter.
1) Open the vacuum cleaner cover and take out the frame with the inow lter.
2) Replace the inow plastic foam lter with a new one a together with the frame put it back into the vacuum
cleaner. Ensure that the ribbing of the lter frame always faces outwards and that the black foam part of the
lter faces outwards also.
Replacement of the inow H.E.P.A. lter
1) Disconnect the hose from the vacuum cleaner.
2) Open the vacuum cleaner cover and remove the dust container by pulling it up with its handle.
3) Press the safety lock and open the bottom lid of the container.
4) By turning remove the H.E.P.A. lter from the container and replace with a new one.
5) Insert the H.E.P.A. lter back into the container and turn it to lock it into position.
6) Close the bottom lid of the container. Make sure the safety lock button is engaged.
7) Place the dust container back into the vacuum cleaner.
Replacement of the outow H.E.P.A. lter
1) Press the safety lock to open the frame of the outow lter.
2) Replace the outow lter together with its plastic frame.
3) Replace the plastic foam lter with a new one a together with the frame put it back into the vacuum cleaner.
Ensure that the black foam always faces into the vacuum cleaner and the white foam outwards. This will ensure
that at the outow the rough particles will be ltered out before the ne particles.
To clean the outer parts of the vacuum cleaner, use a soft cloth dipped in lukewarm water. Do not use harsh
cleaning uids, paint thinners or solvents. These can damage the surface of the appliance.