EasyManua.ls Logo

Sencor SWS 280 - Precautions and Safety; General Precautions

Sencor SWS 280
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN – 10
Except “SNOOZE” button, press any buttons to stop the snooze
alarm. Otherwise, the alarm signal sounds for about 2 minutes, and
then stops automatically.
9. LOW BATTERY INDICATION
The low battery icon “ ”will appear l indicating that thermo sensor
is in low battery status. The batteries should be replaced.
10. BACKLIGHT
Slide Dimmer Hi/Lo Switch (B2) to select the bright or dark display
Press “SNOOZE/LIGHT” button (B1), back light states for 5 seconds.
11. PRECAUTIONS
Use a pin to press the reset button (B5) if the Unit does not work
properly.
Avoid placing the clock near interference sources/metal frames such
as computer or TV sets.
The clock loses its time information when the battery is removed.
Do not expose it to direct sunlight, heavy heat, cold, high humidity or
wet areas
The outdoor sensor must not be set up and installed under water.
Set it up in away direct sunlight and Rain
Never clean the device using abrasive or corrosive materials or
products. Abrasive cleaning agents may scratch plastic parts and
corrode electronic circuits
If there is any inconsistency of weather forecast between Local
Weather Station and this unit, the Local Weather Station’s forecast
should prevail. The manufacturer will not take responsible for
incorrect forecasting from this unit

Related product manuals