Seneca Z109REG2 - User Manual

ENGLISH 1/16
MI004202-E
This document is property of SENECA srl. Duplication and reproduction of it are forbidden (t partial), if not authorized.hough
Contents of present documentation refers to products and technologies described in it. Though we strive for reach perfection
continually, all technical data contained in this document may be modified or added due to technical and commercial needs.
It’s impossible eliminate mismatches and discordances completely. Contents of present documentation is anyhow subjected to
periodical revision. I don’t hesitate to contact our structure or to write us to e-mail addresses as abovef you have any questions
mentioned.
SENECA s.r.l.
Via Austria, 26 – 35127 – PADOVA – ITALY
Tel. +39.049.8705355 – 8705359 Fax. +39.049.8706287
Internet site: Technical assistance:
www.seneca.it support@seneca.it
Commercial reference: sales@seneca.it
Chapter index
Page
1. Preliminary warnings
2
2. Description and characteristics
2.1 Module description
2.2 General characteristics and features
2
3. Technical specifications
3.1 Input
3.2 Outputs
3.3 Connections
3.4 Power supply
3.5 Module case
3.6 Environmental conditions
2
4. Preliminary instructions for use
4
5. Electrical connections
5.1 Safety measures before use
5.2 USB interface
5.3 Connections
5.4 Power supply
5.5 Universal input
5.6 Analog and relay outpu strobe inputt /
4
6. Configuration
6.1 / surInput selection Mea ing scale
6.2 START ENDand setting at will
6.3 Output selection
6.4 through a PCConfiguration
6.5 Jumpers position
6.6 LED indications on the frontal panel
5
7. Purchase order code
8
8. Module layout
8
9. Decommissioning and disposal
8
USER MANUAL Z Line
Z109REG2-1
Universal converter module
with galvanic insulation
EN

Seneca Z109REG2 Specifications

General

Brand	Seneca
Model	Z109REG2
Category	Control Unit
Language	English