ENGLISH 1/8
MI004284-E
This document is property of SENECA srl. Duplication and reproduction of it are forbidden (though partial), if not authorized.
Contents of present documentation refers to products and technologies described in it. Though we strive for reach perfection
continually, all technical data contained in this document may be modified or added due to technical and commercial needs.
It’s impossible eliminate mismatches and discordances completely. Contents of present documentation is anyhow subjected to
periodical revision. If you have any questions don’t hesitate to contact our structure or to write us to e-mail addresses as above
mentioned.
SENECA s.r.l.
Via Austria, 26 – 35127 – PADOVA – ITALY
Tel. +39.049.8705355 – 8705359 Fax. +39.049.8706287
Internet site: Technical assistance: www.seneca.it support@seneca.it
Commercial reference: sales@seneca.it
2. Description and characteristics
2.1 Module description
2.2 General characteristics and features
3. Technical specifications
3.1 Input
3.2 Outputs
3.3 Connections
3.4 Power supply
3.5 Module case
3.6 Environmental conditions
4. Preliminary instructions for use
5. Electrical connections
5.1 Safety measures before use
5.2 USB interface
5.3 Connections
5.4 Power supply
5.5 Thermoresistance input
5.6 Analog output
6. Configuration
6.1 Input selection / Measuring scale
6.2 START and END setting at will
6.3 Output selection
6.4 Configuration through a PC
6.5 Jumpers position
6.6 LED indications on the frontal panel
9. Decommissioning and disposal
Thermoresistance
converter module
with galvanic insulation
EN
To Next Page
Need help?
General