Fireplace stove SENKO SP 6
1.3. CHIMNEY
The replace stove is connected to the chimney with a rosette with a
diameter of 150 mm. It is necessary to ensure that the connection between
the rosette and the chimney is tight. If the replace stove is separated from
the chimney opening (not recommended), it is connected with a standard
ue pipe with a diameter of 150 mm.
We recommend that the chimney be equipped with a chamber for
collecting solid materials and possible condensation products, and that
it be placed under the entrance to the smoke duct in such a way that it can
be easily opened and inspected through the leak-proof door.
1.3.1. CHIMNEY POT
The chimney pot must meet the following conditions:
the same internal cross-section as that of the chimney,
cross-section at the exit not less than twice the internal cross-
section of the chimney,
made in such a way as to prevent the entry of rain, snow, leaves
and other foreign things into the chimney,
made in such a way as to enable the ejection of combustion
products in case of wind from any direction and slope,
Placed in such a way as to enable proper dispersion and dilution of
the combustion products outside the reux (ow back) zone, as back
pressure is created in it. For this reason, it is necessary to observe
the restrictions listed in Picture 1,
it must not have mechanical devices for suction of ue gases.
To Next Page
Loading...
