Using the headphones
16 | ACCENTUM PLUS
Pairing the headphones with a Bluetooth
device
In order for you to pair the headphones with a Bluetooth device, the
headphones have to be close to the Bluetooth device.
1. Press the multi-function button for 5 seconds.
The headphones switch to pairing mode. The LED flashes alter-
nately white and red.
2. Activate Bluetooth on your Bluetooth device.
3. Via the menu of your Bluetooth device, start the search for new
Bluetooth devices.
All active Bluetooth devices in the proximity of your Bluetooth
device are displayed.
4. From the list of found Bluetooth devices, select “ACCENTUM
PLUS”. If necessary, enter the default pin code “0000”.
5. If pairing was successful, you hear the voice prompts “Pairing
successful” and “Connected” one after the other. The LED flashes
white 3x.
If you switch on the headphones for the first time (the pairing
list is empty), they automatically switch to pairing mode.
If the headphones were switched off, they will switch on first.
In this case, you have to press and hold the multi-function
button longer.
By default, the name of the headphones is “ACCENTUM PLUS”.
You can individually adjust the name in the Smart Control
app (> 18).
If no connection is established within 2 minutes, pairing mode
is terminated and the headphones switch to standby mode. If
necessary, repeat the steps described above.
5s
......
ACCENTUM PLUS
ON
3x
1. 2.
3.
4.
To Next Page
Loading...
