DEFRES EN
Using the RS 5000 EN
RS 5000 |19
Selecting a hearing profile
To select the hearing profile that best suits you, proceed as
follows:
Hearing profile 1
1
st
segment lit
Low-frequency tones
are slightly boosted to
provide a warm, full
sound. High-frequency
tones are reproduced
less piercing and
clanking.
yes
Hearing profile 2
2
nd
segment lit
High-frequency tones
are strongly boosted to
provide a crystal-clear
sound, especially for
sibilants and high-
frequency tones such as
twittering of birds.
yes
Hearing profile 3
3
rd
segment lit
Low-frequency tones
are attenuated so that
they cannot mask high-
frequency tones.
yes
1 Switch your audio source on and
select a program where speech is
foregrounded.
2 Put the stethoset receiver on and
make sure that only this receiver
is connected to the transmitter.
Otherwise, a hearing profile
cannot be adjusted.
3 Use the L and R buttons on the
transmitter to adjust the balance
(see page 17). This ensures that
each subsequently selected
hearing profile is perfectly
matched to your left/right bal-
ance setting.
Pro
file
Hearing profile LED Meaning
Com
pres
sion
ON
RS_5000_570727_0117_PRT.book Seite 19 Montag, 10. Oktober 2016 2:52 14
To Next Page
